ST6814
Ex Tax: $0.00
The oven is designed to operate at 300°F maximum operating temperature and includes the following special features:
- 4.5 inch thick insulated walls, ceiling and a 3/16 Plate floor
- 1 Circulation fan
- CRS exterior painted machine gray
- Aluminized interior
- UL listed Control Panel
- Single Set Point electronic temperature controller and high limit
- Batch Timer ( with audible & visual alarm with front panel reset)
- Batch timer (end of cycle to shut heat down)
- Exhaust 1000 CFM
- Louvered adjustable side walls for pressure & return
- Class A oven design
- Purge timer set for 7 minutes
- Rated for .9 gallons of solvent per batch
- Modular construction to fit through 10 x 10 opening
- Main terminal strip labeled to drawing for connection after assembly
- Door opening of a full 72
- Designed to NFPA 86
Batch Oven Specifications:
Effective Work Area: |
72 W x 96 H x 168 L |
External Dimensions: |
164 W x 144 H x 181 L |
KW: |
140 |
Recirculation Fan: |
10,000 CFM; 7.5 HP |
Electric: |
TBD |
Oven Construction:
Outside:
Oven exterior to be constructed of heavy gauge carbon steel with structural members and painted machine gray. Oven to be built in modular sections.
Inside:
Oven interior to be constructed of Aluminized steel.
Circulation System:
1 36 inch Dia fan and shaft, Horizontal airflow from right to left.
Heating System:
28- 5000 watt heater will be housed in the plenum to heat the air to desired temperature. The plenum will be top mounted and the air will be circulated in a horizontal pattern. The air will enter the chamber on the right hand side and return on the left hand side.
Doors:
The unit will have two doors held closed by FM approved slam latches. The door opening will be a full 72 with heavy duty Kason strap hinges.
Control Console:
The control panel for the oven will be on the right hand side of the chamber. The panel will house the electrical components and be NEMA 1 and UL rated.
Exhaust:
The unit will have a 1000 CFM exhaust on the top right of the unit. The exhaust will be on all the times.
Purge Timer:
The unit will have a purge timer set for 7 minutes. The timer will exhaust the air for 7 minutes before allowing the heat to turn on.
Class A Rated:
The unit is designed to handle .9 gallons of solvent per batch.
Uniformity:
The unit will meet the standard +/- 5 F to the maximum operating temperature of 300F in 805 of the empty chamber. The standard 9 point survey will be applied.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: